正规线上手机赌钱平台

全国咨询热线

企业动态

当前位置:首页 - 新闻资讯 > 企业动态 >

正规线上手机赌钱平台:玻璃隔断上下固定靠谱吗?

来源: 日期:2020-06-13 发布人:admin
  在进行装修中大多数业主都会选择使用隔断设计,特别是玻璃隔断的使用,简单大方又能增强视觉观感,那么这种隔断要怎么做呢?玻璃隔断安装工艺有哪些呢?正规线上手机赌钱平台带大家一起来了解一下吧!
  In the process of decoration, most owners will choose to use partition design, especially the use of glass partition, which is simple and generous and can enhance the visual impression, so how to do this partition? What is the installation process of glass partition? Let's get to know each other!
  玻璃隔断上下怎样固定
  How to fix up and down the glass partition
  1、实际上应该考虑玻璃不能顶天立地,上下必须加槽。用大芯板做好槽固定好,加木材封面也好。
  1. In fact, we should consider that glass can not stand on the ground, and must be slotted up and down. Fix the groove with big core board, and add wood cover.
  2、玻璃隔断用大芯板做就行了,大芯板上可以贴铝塑板、柚木、橡木、樱桃木、胡桃木等都行。
  2. Glass partition is made of big core board, which can be pasted with aluminum-plastic board, teak, oak, cherry, walnut, etc.
  3、大芯板上留玻璃槽就可以固定了,顶面也要做造型留玻璃槽,做法也差不多。
  3. The big core plate can be fixed by leaving a glass slot, and the top surface also needs to be molded to leave a glass slot, which is almost the same.
  4、在石膏板的位置有玻璃夹,用角钢固定好玻璃夹与楼板连接,定好位置,下面是一个L姓的夹子,把玻璃放好后,有个不锈钢条扣。梢曰徊A,活连接,门就不说了。
  4. There is a glass clamp at the position of gypsum board. Fix the glass clamp with angle steel and connect it with the floor slab. Fix the position. Here is a clamp with the surname L. after putting the glass in place, there is a stainless steel bar to fasten it. You can change the glass and connect it flexibly. The door won't say.
       正规线上手机赌钱平台
  玻璃隔断如何安装
  How to install the glass partition
  1、弹线
  1. Line snapping
  根据楼层设计标高水平线,顺墙高量至顶棚设计标高,沿墙弹玻璃隔断垂直标高线及天地龙骨的水平线,并在天地龙骨的水平线上划好龙骨的分档位置线。
  According to the horizontal line of the floor design elevation, measure the height along the wall to the ceiling design elevation, snap the vertical elevation line of the glass partition along the wall and the horizontal line of the sky and earth keel, and draw the dividing position line of the keel on the horizontal line of the sky and earth keel.
  2、安装大龙骨
  2. Installation of large keel
  1.地骨安装:根据设计要求固定天地龙骨,如无设计要求时,可以用Ф8~Ф12膨胀螺栓或3~5寸钉子固定,膨胀螺栓固定点间距600~800mm。安装前作好防腐处理.2.沿墙边龙骨安装:根据设计要求固定边龙骨,边龙骨应启抹灰收口槽,如无设计要求时,可以用Ф8~Ф12膨胀螺栓或3~5寸钉子与预埋木砖固定,固定点间距800~1000mm.安装前作好防腐处理。
  1. Ground bone installation: fix the keel of heaven and earth according to the design requirements. If there is no design requirement, it can be fixed with Ф 8 ~ Ф 12 expansion bolts or 3 ~ 5 inch nails. The spacing between the fixed points of expansion bolts is 600 ~ 800mm. Anti corrosion treatment shall be done well before installation. 2. Install along the wall keel: fix the side keel according to the design requirements, and open the plastering and closing groove for the side keel. If there is no design requirement, fix it with Ф 8 ~ Ф 12 expansion bolt or 3 ~ 5 inch nail and embedded wood brick, with the fixed point spacing of 800 ~ 1000mm. Anti corrosion treatment shall be done well before installation.
  3、主龙骨安装
  3. Installation of main keel
  根据设计要求按分档线位置固定主龙骨,用4寸的铁钉固定,龙骨每端固定应不少于三颗钉子.必须安装牢固。
  According to the design requirements, the main keel shall be fixed according to the location of the grading line, and fixed with 4-inch iron nails. Each end of the keel shall be fixed with at least three nails. It must be installed firmly.
  4、小龙骨安装
  4. Installation of small keel
  根据设计要求按分档线位置固定小龙骨,用扣榫或钉子固定.必须安装牢.安装小龙骨前,也可以根据安装玻璃的规格在小龙骨上开安装玻璃槽。
  According to the design requirements, fix the small keel according to the position of the grading line, and fix it with the tenon or nail. It must be installed firmly. Before installing the small dragon bone, you can also open the installation glass slot on the small keel according to the specifications of the installed glass.
  玻璃隔断安装工艺包括哪些?隔断上下怎么固定更靠谱?
  What is the installation process of glass partition? How to fix the partition up and down more reliable?
  5、安装玻璃
  5. Install glass
  根据设计要求按玻璃的规格安装在小龙骨上;如用压条安装时先固定玻璃一侧的压条,并用橡胶垫垫在玻璃下方,再用压条将玻璃固定;如用玻璃胶直接固定玻璃,应将玻璃先安装在小龙骨的预留槽内,然后用玻璃胶封闭固定。
  According to the design requirements, the glass shall be installed on the small keel according to the specifications of the glass; if the strip is used for installation, the strip on one side of the glass shall be fixed first, and the rubber pad shall be used under the glass, and then the strip shall be used to fix the glass; if the glass is fixed directly with the glass glue, the glass shall be installed in the pre reserved groove of the small keel first, and then sealed and fixed with the glass glue.
  6、打玻璃胶
  6. Glazing glue
  首先在玻璃上沿四周粘上纸胶带,根据设计要求将各种玻璃胶均匀地打在玻璃与小龙骨之间.待玻璃胶完全干后撕掉纸胶带。
  Firstly, the paper tape is pasted around the glass. According to the design requirements, all kinds of glass glue are evenly placed between the glass and the small dragon bone. After the glass glue is completely dry, tear off the paper tape.
  7、安装压条
  7. Installing the bead
  根据设计要求将各种规格材质的压条,将压条用直钉或玻璃胶固定小龙骨上.如设计无要求,可以根据需要选用10*12mm木压条、10*10mm的铝压条或10*20mm不锈钢压条。
  According to the design requirements, the battens of various specifications and materials shall be fixed on the small keel with straight nails or glass glue. If there is no requirement in the design, 10 * 12mm wood battens, 10 * 10mm aluminum battens or 10 * 20MM stainless steel battens can be selected as required.
  以上是关于玻璃隔断工艺的相关内容,由正规线上手机赌钱平台整理提供,想要了解更多欢迎咨询网站。
  The above is about the glass partition technology, which is provided by Jinan glass partition finishing. If you want to know more, please contact us Website.

上一篇:浴室玻璃隔断怎么选购?
下一篇:医用感应自动门伪故障怎么维修?

正规线上手机赌钱平台-赌博最正规网站平台