正规线上手机赌钱平台

全国咨询热线

行业新闻

当前位置:首页 - 新闻资讯 > 行业新闻 >

正规线上手机赌钱平台:单层玻璃隔断的安装方法有哪些?

来源: 日期:2020-05-12 发布人:admin
  一、要说单层玻璃隔断的安装方法,首先要做的就是弹簧。根据地面设计标高水平,沿墙高至吊顶设计标高水平,沿墙反弹玻璃隔断垂直标高线与地面龙骨标高线,在地面龙骨水平线上画出龙骨分割线。
  1、 To say the installation method of single-layer glass partition, the first thing to do is spring. According to the design elevation level of the ground, along the wall height to the design elevation level of the ceiling, along the wall rebound glass partition vertical elevation line and the ground keel elevation line, draw the keel dividing line on the ground keel horizontal line.
  其次,我们要做的下一件事是安装土骨头。我们应该按照设计要求固定地面龙骨和天空龙骨。如果没有设计要求,我们可以使用直径为8 - 12的膨胀螺栓或直径为3 - 5英寸的钉子。膨胀螺栓的固定点间距为600-800mm。我们需要知道的是玻璃隔断在安装前应该进行防腐处理。
  Secondly, the next thing we need to do is to install the earth bone. We should fix the ground keel and sky keel according to the design requirements. If there are no design requirements, we can use 8 - 12 diameter expansion bolts or 3 - 5 inch diameter nails. The fixed point spacing of expansion bolt is 600-800mm. What we need to know is that the glass partition should be antiseptic before installation.
  三、在主龙骨的安装过程中,我们要做的就是根据分界线的位置,按照设计要求用4寸钉来固定主龙骨。龙骨两端至少用三根钉子固定。所以玻璃隔断需要安装牢固。
  3、 During the installation of the main keel, we need to fix the main keel with 4-inch nails according to the location of the dividing line and the design requirements. The two ends of the keel shall be fixed with at least three nails. Therefore, the glass partition needs to be installed firmly.
  四、其次,我们要安装小龙骨。根据设计要求,单层玻璃隔断应按坡线位置放置固定小龙骨,并用榫或钉子固定。确保安装是安全的。安装小龙骨前,还可以根据安装玻璃的规格,打开小龙骨上的安装玻璃槽。
  4、 Secondly, we need to install small keels. According to the design requirements, the single-layer glass partition shall be placed and fixed with small keel according to the slope line position, and fixed with tenon or nail. Make sure the installation is safe. Before installing the small dragon bone, you can also open the installation glass slot on the small keel according to the specifications of the installed glass.
正规线上手机赌钱平台
  五,所有上述步骤完成后,应该在小龙骨安装玻璃根据设计要求,如面板安装,首先带固定在一侧的玻璃,再用玻璃下的橡胶垫,再用板条固定玻璃,如直接与玻璃胶固定玻璃、玻璃安装在一个小龙骨先储备油箱,再用玻璃胶密封固定。
  5、 After all the above steps are completed, the glass should be installed on the small keel according to the design requirements, such as panel installation, first with the glass fixed on one side, then with the rubber pad under the glass, then with the slat to fix the glass, such as directly fixed with the glass glue, glass installed in a small dragon bone first reserve tank, then sealed and fixed with the glass glue.
  六、我们还需要做玻璃胶水。在玻璃四周粘贴纸带,根据设计要求在玻璃与小龙骨之间均匀地打上各种玻璃胶。胶水完全干后,撕掉胶带。
  6、 We also need to make glass glue. Paste paper tape around the glass, and apply various glass glue evenly between the glass and the small dragon bone according to the design requirements. When the glue is completely dry, remove the tape.
  我们不需要做的就是安装板条。根据设计要求,玻璃隔断采用直钉或玻璃胶水将小龙骨固定。玻璃隔断设计无要求,可按要求制作10×12mm木方、10×10mm铝方或10×20mm不锈钢方。这样,单层玻璃隔断成功安装。
  What we don't need to do is install the slats. According to the design requirements, the glass partition adopts straight nails or glass glue to fix the small keel. There is no requirement for the design of glass partition. 10 × 12mm wood cube, 10 × 10mm aluminum cube or 10 × 20mm stainless steel cube can be made as required. In this way, the single-layer glass partition is successfully installed.
  以上是关于单层玻璃隔断的安装有哪些知识的详细介绍,希望本文能对您有所帮助。
  The above is a detailed introduction about the installation of single-layer glass partition. I hope this article can help you.

上一篇:玻璃隔断安装对环境有什么要求?
下一篇:玻璃隔断的基本常识

正规线上手机赌钱平台-赌博最正规网站平台